Stratigicon

physicallayouts.png
To remind viewers of the components of the transceiver unit, I have reproduced Meshtastic’s own image and added some things that it leaves out.

relayradiounits.png
Lined up properly, it would take fewer than 800 stations to completely span Afghanistan from a user on the southwest border to another user on the northeast border. One thing we'll get around to in the third video is that repeater radios, set on high points in the landscape, make connections between remote radios easier since there is

Prospecti.png

2radiounits.png

The task at hand is to get two Meshtastic-capable transceivers communicating with each other.

To do that:

In order to form a meshwork it is first necessary to connect two Meshtastic stations to each other.

Start with a new computer, tablet, smartphone, etc. Install a copy of Meshtastic on that device.

Assemble and power up a new Meshtastics transceiver.

The screen show “Communicating with device” while it is trying to set things up.

As soon as your pad, computer, or cell phone connects by Bluetooth with the new device it will show a screen with the newly acquired transceiver listed under “Available Radios.” You should click on the black dot next to your radio's designation.

CURSOR ON NEW RADIO'S NAME to click

Communicating with radio show up on Meshtastic Screen

avvavconnectionrequest
The radio device wants my computer to copy some numbers from its little screen by typing them into the box next to “Passcode.”

bloothscreen shows 9bb4 is connected to mesh
As soon as you succeed in correctly typing the number displayed on the radio's view screen, the computer display will show the newly chosen unit as “Subscribed to mesh.”√

② Click on messages.

③ this is what you will see after going to messages

④ this is what you will see after going to bluetooth screen.

⑤ This is what you will see on the nodes screen.

gsm.png

channels.png

9bb4isavailableradiobluetoodscreen

ipadisconnectedto9bb4_not9bc4

bluetoothoninipad_2

bluetoothoninipad

just_turned_on_a_new_transciever.

meshtastic-meshmap.png

meshtasticscontactsscreen_mg_2

meshtasticscontactsscreen_img.png

}} listoftasks.png

}} mymessagesonright.png

}}

shouldnotexpect_message

subscribedtomesh.png

meshradio.png

meshtasticopeningscreen

nodes_screen_3_

radiowithcacle.png

radiopix1.png

relayradiounits.png

set_about_meshtastic.png

set_appsettings.pn

settingsscreen_5i_.png

set_qr_code.png

9bc4isavailableradiobluetoodscreen

9bb4isavailableradiobluetoodscreen.png

9bc4isavailableradiobluetoodscreen_2_2_2_2.png

twonodes.png
When the new radio and the new instance of Meshtastic software are finally set up, this is the kind of screen that you will see.

avvavconnectionrequest
The radio device wants my computer to copy some numbers from its little screen by typing them into the box next to “Passcode.” Copy, then click “connect.”

avvavconnectionrequest

screen shows box to type passcode into

meshtasticscontactsscreen_mg_2

Screen shows ⓪ and Meshtastic 9xz0

bluetooth_screen_2_.png

bluetooth screen shows one connected radio

ipadseekingitanewradio.png

∆